Joined: Jun 09, 2011 Posts: 776 Location: Bellmore, NY
Posted: Sat Dec 24, 2011 9:04 pm Post subject: While I have the body tub pulled
Should I install a body mounting kit? Even with all new suspension, the jeep clatters and creaks like it is falling apart going down the road. The engine, transmission, and transfer case are all rebuilt like new. The the leaf springs, wheel and kingpin bearings, and shocks have all been replaced. The tires and rims, and motor mounts are new as well.
the jeep clatters and creaks like it is falling apart going down the road.
You will have to determine /locate the source of each clatter and creak then share your findings with us and then we may be able to offer some accurate advise. _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
Joined: Jun 09, 2011 Posts: 776 Location: Bellmore, NY
Posted: Sun Dec 25, 2011 1:48 am Post subject:
I'll try to isolate specific sounds when I get the vehicle up and running in a few weeks. In the meantime, the tub will be off for the frame swap. Considering this was not done when the vehicle was "restored", the body mounts are probably 60 years old, and this would be a good time to replace them. I'll replace the toe-board gussets as well. Their being so rusted out they no longer hold the body to the frame probably accounts for some of the noise. The "rebuilder" also put a metal bar in between the right motor mount and what looked like the bottom of the radiator. This was not secured to anything, and I could easily move it around.
Joined: Nov 24, 2010 Posts: 1390 Location: Orem, UT
Posted: Sun Dec 25, 2011 6:58 am Post subject:
Sounds like you are talking about the z-bar and your rig is missing the left one. They were there to allow the power plant along with the radiator to all be removed in one shot. It should have a washer and a keeper pin keeper at the engine end.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum