Joined: Jun 25, 2008 Posts: 583 Location: Kern Co.
Posted: Mon May 10, 2010 3:48 pm Post subject: Generator Oil Plug
I've read the generator documentation and I'm getting ready to pull my generator to add oil. I see the small plug on the front cover but it's behind the pulley. I was thinking of using a small rubber tube to sneak the oil into the fill hole.
Anyone dealt with this already that can provide tips?
Also, is the rear bearing sealed or am I forced to remove the back cover.
The oil reservoir is an overhaul servicing item. It specifies an exact quantity of oil to be added to the reservoir during assembly. You do not fill the cavity. If you have evidence the oil has leaked out or the bearing is noisy then you must remove the generator, clean the cavity out, inspect the bearing and add the specific amount of oil again. _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
Joined: Jun 25, 2008 Posts: 583 Location: Kern Co.
Posted: Wed May 12, 2010 10:15 am Post subject:
Thanks for the feedback guys.
I don't see any leaking but who's to say it didn't already leak out 30 years ago? I'd like to put a little in and see what happens. Worse that could happen is the old gummed up oil get a thinned out and bearings get some fresh lube.
Also, what's wrong with trying to poor out the old oil and adding new?
who's to say it didn't already leak out 30 years ago
If that is true then your bearing should have started singing 25 years ago!
Quote:
Also, what's wrong with trying to poor out the old oil and adding new?
I never said it was a bad idea. I said it was normally only done at overhaul.
Note I did say it is not meant to be filled completely. There must be expansion room so when the bearing gets warm and the fluid expands it is not force out onto the Generator's armature, brushes and fields causing poor generator performance. So if you must satisfy some need to add fluid then you must first determine how much is in there then add only enough to bring it up to the specified quantity.
These generators require a lot less maintenance than their WWII predecessors. I am a bit old fashion and believe that if it's "Not broke then don't fix it". _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum