Bellhousing cable boot

[garcia63]

I will be replacing the cable boot to the bellhousing and noticed that there is some thread marks on the inside of the hold where the cable goes into the fork. I looked at the illustrations and could not find a part that goes in there.
What part would go there? I am trying to link a photo.

[wesk]

You can see the threaded nipple attached to the boot here:



This is the threaded nipple in the bell housing just above the circled stud.

You failed to indicate which model jeep you have.

If M38 ORD 9 SNL G-740 Page 50, lower view in Fig 02-2, Item X.

If M38A1 or M170 ORD 9 SNL G-758 Page 56, Item X.
_________________
Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100

Mjeeps photo album: http://www.willysmjeeps.com/v2/modules.php?set_albumName=Wes-Knettle&op=modload&name=gallery&file=index&include=view_album.php

[garcia63]

M38--thank you sir--Part Number 8328439 Clutch cable boot adapter would be the part I was looking for--already found it with a couple of vendors.