Joined: Jun 09, 2011 Posts: 776 Location: Bellmore, NY
Posted: Wed Apr 02, 2014 12:50 pm Post subject: So, I went to install the marine rear bumper reinforcement
and I noticed the present rear bumper is welded to the frame. I did some research, and didn't see if this was normal or not, but apparently the marine reinforcement was welded in place and then bolted. Anybody have any suggestions? _________________ 1952 M38A1
Marine core reinforced rear bumper, military transistorized turn signal upgrade, arctic heater, 11" drum brakes, 200L PTO winch, Huffy overdrive, deep water fording kit, RT 68 vehicle mounted radio, Trac Locs front and rear.
www.danhenk.com
The original bumper is welded at the point of contact with the pintle plate on the chassis as far as I know. Then the USMC reinforcement frame member is slipped over the original. Then everything is bolted back up.
I checked my jeep with the USMC lifting hooks and it does not appear to be welded... if it is welded in place the hardware currently installed is covering the welding.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
Forum FAQ
Search
Usergroups
Profile
Log in to check your private messages
Log in
