Posted: Sat May 17, 2014 5:49 pm Post subject: Vacuum pump outlet
I just rebuilt my original fuel/vacuum pump.Everything seems to be working fine but I need to know whether or not to plug the vacuum pump inlet.
I currently do not have a set of wipers nor do I have most of the fording valves.The only fording valve I have is the valve on the side of the block at the PVC valve.If I leave the vacuum port open it makes a lot of noise if I plug it the vacuum noise is gone and the engine runs better.
My question therefore is,is it alright to operate for awhile with the vacuum inlet port plugged .
Any insight will be appreciated.
Thanks _________________ 1953 M38a1
1967 M715
1965 m101a1 trailer
1970 M35a2 (sold)
Yes. I assume you are describing the suction port on the pump that is making the noise. You used outlet in your title and inlet in the body of your post. When discussing vacuum it is best to use suction and pressure for those ports. Suction goes to the "T" for the distributor/wipers and pressure goes to the intake manifold. _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
Thank you for clearing that up but you still didn't answer my original question.
Can I operate with the suction port plugged without damaging any valves,diaphragm,etc? _________________ 1953 M38a1
1967 M715
1965 m101a1 trailer
1970 M35a2 (sold)
Is there a reason you are not connecting that port to the wiper "T" where it belongs? All you need to do for the wiper side of the "T" is plug it. But the other side of that "T" provides ventilation for the distributor housing which serves two purposes: 1-evacuates ionized gasses from the distributor, 2-Cools the coil. In hot climates like summer's mid to southern US the coil when consistently overheated will fail prematurely and they are not cheap. _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
Good point Wes,
I'm gonna have to get the tubing and the tee fitting,
That was gonna be my next concern,whether it would be ok to run it with the vacuum not hooked up to the distributor.
I'll try to get the necessary tubing and fittings .thanks again _________________ 1953 M38a1
1967 M715
1965 m101a1 trailer
1970 M35a2 (sold)
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum