Search found 16 matches

Hi Wesk....I do have the military shop manual and will read throught the electrical part and try to cordinate it with your attached diagram...I will also buy a multmeter to start the testing procedure ...

Hi wesk...its been a while....anyhow, although I have replaced my rad, brakes, wheel bearings, steering wheel and other mechanicals.....I have never diagnosed electrical components....I have no clue w ...

My 67' M38A1 started and ran well 2 weeks ago on first start of season. Yesterday, after 2 weeks of rest I started the jeep and it started well. After running for 1-2 minutes it started to sputter, mi ...

Wow....thanks Wes....tools, a manual and torque specs....that's all I require...one last question though....do both front and rear yokes on the front driveshaft use the same yoke and seal?

Very bes ...

Greetings,

I am in the process of trying to take off the front transfer case yoke (at front driveshaft) to get at the seal due to leakage. can anyone please explain in detail and in point form how ...

OOOPS....Hi Scott....new email for info requested...edkovacs@outlook.com.....sorry for the confusion.

lesk

Hi Scott,

I have everything you need.....manuals, capacities etc....contact me at bkovacs@outlook.com. I have a 67' M38A1 CDN2 and I also had problems figuring out where to get manuals, capacities ...

Hi Rob....sorry for being so tardy in my reply....I checked the PM area and there appears to be no message.

You can contact me at leskgeo@outlook.com. Lots to discuss if you have the time.

Regar ...

Thanks Wesk....I have interpreted your response as....if you are not going to use the fording capability of your jeep....you can go ahead and plug the two holes in your air cleaner.

lesk

Hi Wesk....thanks for the picture & diagram you added...I forgot to respond to your question....I took the hose off from the oil filler pipe end and blew air into the fording valve & crossover ...

Wow...thanks WESK....OK firstly, I have no clue as to what a URL is but I will do some discovery. I also do not know how to post pics onto a public website...I never knew any existed ( I am old school ...

Wow....never thought it would be this difficult. I had a post requesting information....Wesk responded that it would be nice to have a picture to follow up on the written request....go figure!

lesk

Wow.....I just cannot get a picture into this post.....I tried to follow directions but I just cannot insert a picture here....anyone help?

lesk

[/img]

I tried to post a picture but did not no how. The picture explains it all.

lesk

Today I was re-testing to see if my upper fording valve was in the open position. I disconnected the tube closest to the fording valve in between the fording valve and oil filler tube....I blew in and ...


Create an account	Home · · Forums · · Articles · · Downloads · · Photo Gallery


PHP-Nuke Copyright © 2005 by Francisco Burzi. This is free software, and you may redistribute it under the GPL. PHP-Nuke comes with absolutely no warranty, for details, see the license.