Search found 77 matches

Hello Richard,

Have you checked the rear clutch lever and see if the levers are in the correct position.
The levers must be aligned opposite each other.
There are repro parts out where the lever ...

If you don't get the loops, you could make them yourself.
Take a sturdy wire of the right size,
https://up.picr.de/44409768fa.jpg

and if you have an original one as a template,
bend the required ...

If you don't have an ignition spark although there is 24 volts at the distributor and you have already cleaned the contacts, the distributor shaft rotates when you turn the engine, you have also alrea ...

Had the same experience with the rivets from a M38A1 dataplate set a few years ago.
At first glance, the data plates looked very good.
But even when removing the protective film, some of the color c ...

The normal stencil size was 1" for the "caution-do not overfill allow for expansion" lettering.

Frank

But I can turn the colour on.

https://up.picr.de/42330734fu.jpg

On the picture (in the picture on the right) the 2nd picture what Wes has posted(right arrow).
It shows the same place where the ...

Today, 60 years ago, the "cold war" was a little bit hotter.

The Tank "stand off" in Berlin at Checkpoint Charlie October 27th, 1961

Time warp:
Same place today
https://up.picr.de/42328024zv.j ...

Hello Claudio,

the routing is shown in the Part TM.

The main difference between M38A1 and M170 is the lengh and that the rear fuelline goes to the left side, instead the 90° elbow that the M38A ...

Hello Murray,

you can try those Dry transfers, also called rub-ons or rubdowns, for lettering
what you need on your Radio set.

For example from decadry, or what you can buy in the UK.
Choose t ...

MB/GPW and CJ's didn't have bottom plates on the mounts.

M38 and M38A1 had them for the lower radiator support rods for complete Powerplant changing, the Army did.

Frank

Lower attachment point for support bar from Fording Kit Intake hose

It has all infos and specs you need.

Take a look to page 254
Group-13 Wheels, Hubs and Drums
1311- Wheels, Hubs and drums

There you find the Bearings (Cup & Cone) whith the specs.

So yo ...

These should be right for the MUTT and will fit M151 & M416 wheel hub's,
not for Willys M38 / M38A1

Just my opinion

Frank

Hello Marcus,

you should contact Harold Bergers in the Netherlands.
He can certainly tell you the day and hour, your NEKAF was assembled in the plant of Kaiser- Frazer in Rotterdam.

Sincerely
...

What is coming is not really a surprise, rather a confirmation.
Seems familiar to me, I’ve seen it somewhere before.

Body work

Now I have two M38A1 bodys left.
Both in very rough condition.
W ...


Create an account	Home · · Forums · · Articles · · Downloads · · Photo Gallery


PHP-Nuke Copyright © 2005 by Francisco Burzi. This is free software, and you may redistribute it under the GPL. PHP-Nuke comes with absolutely no warranty, for details, see the license.