Search found 19 matches

On June 5th and 6th there will be a military vehicle show and parade.
This is being organized to commemorate the 70th anniversary of the end of the 2nd world war.
If anyone wants some more informati ...

A couple things to check before throwing parts and money at it.
Check point gap and condenser.
Check your spark plugs after it stalls, plug wet probably a spark issue, plug dry probably a fuel issue ...

Are you referring to blue smoke? Cause if it it is then you will be tearing the old girl down. If it's white smoke you should be noticing your antifreeze dropping in the radiator. But if it's brown or ...

My M38A1 was used by the Canadian military, and I assume they used 15W40 all through its service life as"15w40 engine oil" is stencilled onto the inside of the hood in the engine compartment. Also I h ...

Have you checked for vacuum leaks?
The other thing to have checked would be the ingnition timing.
I've seen either of these cause a stammer on hard acceleration.
Also as WesK said if your accelerat ...

Sorry guys got windows 8 on my new computer, still trying to fiqure it out.
if you right click on the address in my previous post and select go to address you can see the picture.
I'm not really ple ...

http://willysmjeeps.com/v2/modules/gallery/albums/album350/photo_2_001.thumb.jpg

this is the picture I was referring to I hope this works.

Brad

If you are talking about passenger side, vertical part of fender well? If so on my M38A1cnd3 (1971) yes there are 4 holes and a reinforcing brace. I will post a couple pics on my member photo album. M ...

That is great looking jeep, and it sounds like you have a terrific family.
Working on a project like that as a family is a wonderful thing that your children remember long after all life's other dist ...

The only concerns I have about the cruising speed were of the drive train. My jeep is a 1971 M38A1 Cdn3. This means it came out with 11 inch brakes not the 9 inch you are all used to. I don't think th ...

Thanks for all the replies, I am planning on getting an overdrive and installing next winter but I wanted to be sure I wasn't hurting my jeep in the mean time running back and forth to cruise nights a ...

So I finally got the jeep out on the hwy for a 20 mile drive. I got up to 60mph engine was screeming, dropped back to 50mph sounded much better.
My question is am I going to hurt my jeep travelling a ...

Thanks for the info Wes, I will be using the cfr # that matches with the ser no on the dash plate when I stencil it on the side.

I have an M38A1cdn3 with two serial numbers one on the dash plate (100180), and one behind the passenger seat (7105014 100089). I have checked with ram tank.ca and both come up with cfr#s 100180 cfr 0 ...

Yep Artificer you are correct, I remembered that there had to be a restriction for the bypass oil filter just couldn't remember where. As long as the original filter housing is used the restriction is ...


Create an account	Home · · Forums · · Articles · · Downloads · · Photo Gallery


PHP-Nuke Copyright © 2005 by Francisco Burzi. This is free software, and you may redistribute it under the GPL. PHP-Nuke comes with absolutely no warranty, for details, see the license.