Create an account Home  ·  ·  Forums  ·  ·  Articles  ·  ·  Downloads  ·  ·  Photo Gallery  
Login
Nickname

Password

Don't have an account yet? You can create one here.

Navigation
· Home
· Article Archive
· Article Submit
· Downloads
· FAQ
· Forums
· Members List
· Photo Gallery
· Private Messages
· Web Links
· Your Account

Search Articles



Forums

1950 M38 no reading on the dash amp meter
Transfer Case rebuild issues
Zerks causing trouble.
1952 M38 converting to 12V
M38A1 Slave Bucket location
M274 A3 Mule For Sale
flywheel advice
conversion from a 12 volt system back to a 24 volt system
M151 A2 + M416 Trailer For Sale
M38 ignition points condensor

Willys M Jeeps Forums


willysmjeeps.com :: Search
 Forum FAQForum FAQ   SearchSearch   UsergroupsUsergroups   ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Search found 7 matches
willysmjeeps.com Forum Index
Author Message
  Topic: Need a couple of dimentions from a few folks
Chad

Replies: 17
Views: 4938

PostForum: Technical Knowledge Base   Posted: Wed Nov 08, 2023 5:16 pm   Subject: Bumper length clue
My original on my 9/52 A1 was the shorter, I needed to replace it and during my research I came across that the shorter bumpers were m38’s and were used on the assembly line for the A1’s until they si ...
  Topic: 2245 Spark Plugs
Chad

Replies: 1
Views: 823

PostForum: M Series Parts Supply & Service Review   Posted: Thu May 18, 2023 9:42 pm   Subject: 2245 Spark Plugs
While working out the details of a purchase from Van Buuren Jeeps I noticed that they also offered NOS 2245 NEKAF sparkplugs. Their site says that they are "Spark plug M38/M38A1 NEKAF wade proof, Auto ...
  Topic: Dana 25 Driver's side Spicer type axle for sale
Chad

Replies: 1
Views: 3378

PostForum: For Sale   Posted: Sun Oct 03, 2021 6:07 pm   Subject: Dana 25 Driver's side Spicer type axle for sale
I bought this axle thinking that the one I had needed to be replaced. Only realized after removing the U-joint seals that I in fact did not need to replace the original axle shaft.

New Spicer axle ...
  Topic: Seeking Early Type M38A1 Rims (5)
Chad

Replies: 0
Views: 2965

PostForum: Wanted   Posted: Sat Feb 06, 2021 9:03 pm   Subject: Seeking Early Type M38A1 Rims (5)
I'm looking for (5) M38A1 early type rims. 16x4.5 5 lug 5.5" centers 1/8" pilot hole with safety bead ridge with an evenly rounded center section non-stepped spoke area.

I could compromise with ...
  Topic: Auto-Lite Generator Rebuild
Chad

Replies: 4
Views: 3994

PostForum: Technical Knowledge Base   Posted: Sat Feb 08, 2020 1:29 pm   Subject: Auto-Lite Generator Rebuild
Cleared the cookies, re-logged into the site but am still receiving "access denied" message. What do you think?
  Topic: Auto-Lite Generator Rebuild
Chad

Replies: 4
Views: 3994

PostForum: Technical Knowledge Base   Posted: Fri Feb 07, 2020 9:19 pm   Subject: Auto-Lite Generator Rebuild
This is it, correct the GHA 4802, thank you

I currently do not access to the album however I would like to request to set up an album.

I'm not certain about the repair kit yet it's on it's way ...
  Topic: Auto-Lite Generator Rebuild
Chad

Replies: 4
Views: 3994

PostForum: Technical Knowledge Base   Posted: Thu Feb 06, 2020 10:02 pm   Subject: Auto-Lite Generator Rebuild
Hope I'm posting this question correctly, (This is my first post) I'm in process of rebuilding my M38A1 generator. It currently has sealed bearings as does the kit that I'm expecting. The oil slinger ...
 
Page 1 of 1
All times are GMT - 6 Hours
Jump to:  

Powered by phpBB © 2001 phpBB Group
Forums ©

 



PHP-Nuke Copyright © 2005 by Francisco Burzi. This is free software, and you may redistribute it under the GPL. PHP-Nuke comes with absolutely no warranty, for details, see the license.