Author |
Message |
Topic: Exhaust Pipe question |
DougK
Replies: 16
Views: 26141
|
Forum: Technical Knowledge Base Posted: Thu Aug 31, 2006 12:49 pm Subject: Exhaust Pipe question |
Ryan:
I purchased my pipe and muffler from AJP George Baxter at the Alameda Convention in 2003. He told me at the time he had one kind from the manufacturer that came with the wrong bend in it. H ... |
Topic: Passenger seat pivot pins |
DougK
Replies: 12
Views: 15813
|
Forum: Technical Knowledge Base Posted: Thu Jan 26, 2006 9:02 pm Subject: Passenger seat pivot pins |
Greg
At the bottom of the pivot bracket just above the base is a small hole. Pry the retaining clip at the end of the chain apart and slip it through the hole. Try and not spread it too far apart ... |
Topic: Shock absorbers |
DougK
Replies: 2
Views: 6554
|
Forum: Technical Knowledge Base Posted: Sat Dec 10, 2005 6:08 pm Subject: Shock absorbers |
My original shocks on the m38 had seen better days. I took them off and showed them to a local supplier of shocks. He ordered the same from Monroe. They came in blue but that is what Scotch Brite a ... |
Topic: Top Bow, "rings, chains and pins" |
DougK
Replies: 2
Views: 7853
|
Forum: Technical Knowledge Base Posted: Tue Aug 16, 2005 12:28 pm Subject: Top Bow, "rings, chains and pins" |
Wes
Thank you for the photo. If that is NOS then my configuration with the rings and chains and cotter pins are correct.
Doug |
Topic: Top Bow, "rings, chains and pins" |
DougK
Replies: 2
Views: 7853
|
Forum: Technical Knowledge Base Posted: Fri Aug 12, 2005 9:02 pm Subject: Top Bow, "rings, chains and pins" |
I posted this on the GEE but thought I might catch an answer over here for those that don't get to the GEE.
I have just installed the windshield brackets that hold the rods from the top bows. I hav ... |
Topic: Where do you put your license plate? |
DougK
Replies: 14
Views: 19094
|
Forum: Announcements, News, Humor Posted: Thu Jun 16, 2005 8:52 am Subject: Where do you put your license plate? |
I made two frames of half inch angle iron. On each frame I welded four washers that I had ground down on one side to where it was almost flat. The flat side was welded to the inside of the frame whe ... |
|