Author |
Message |
Topic: m-38 vs m38a1 24volt components |
Lehr
Replies: 4
Views: 5615
|
Forum: Technical Knowledge Base Posted: Mon May 19, 2008 11:23 am Subject: 24 volt parts |
Hello: Thank you for the answers to my question. Lehr |
Topic: m-38 vs m38a1 24volt components |
Lehr
Replies: 4
Views: 5615
|
Forum: Technical Knowledge Base Posted: Sun May 18, 2008 8:49 am Subject: m-38 vs m38a1 24volt components |
Hello all: My question is; Are any/all the components of the 24volt system of a m38a1 enetrchangable with the m38??? How about any other parts?? Thank you for any input. Lehr |
Topic: drain hole plug device for M-38 |
Lehr
Replies: 2
Views: 5133
|
Forum: Wanted Posted: Tue Mar 11, 2008 10:43 am Subject: drain hole plug device for M-38 |
Hello Hal: Thanks for the info. I got them from John and they are in place... Thanks again Lehr |
Topic: drain hole plug device for M-38 |
Lehr
Replies: 2
Views: 5133
|
Forum: Wanted Posted: Mon Mar 03, 2008 3:48 pm Subject: drain hole plug device for M-38 |
Hello all: I am looking for two drain hole plug devices for the four holes(two on each side of the front floor board) in my 1952 M38. Anyone have these or know where I could purchase same? Thanks m ... |
Topic: thermostat in M-38 |
Lehr
Replies: 5
Views: 6693
|
Forum: Technical Knowledge Base Posted: Wed Nov 14, 2007 9:00 am Subject: thermostat |
Hello: Thanks for the replys. Will follow all suggestions! Thanks again Lehr |
Topic: thermostat in M-38 |
Lehr
Replies: 5
Views: 6693
|
Forum: Technical Knowledge Base Posted: Tue Nov 13, 2007 2:01 pm Subject: thermostat in M-38 |
Hello: My recently obtained m-38 never gets off the 100 mark(temperature) while driving,which leads me to beleive that there is no thermostat. My question before I dig into it. Is there a retainer of ... |
Topic: M-38 Leaning |
Lehr
Replies: 3
Views: 7901
|
Forum: Technical Knowledge Base Posted: Fri Nov 02, 2007 1:00 pm Subject: m-38 leaning |
Hello Wes: Thanks for the info. I think Ill leave it as is for now and perhaps down the road put new springs or re-arch the old Lehr |
Topic: M-38 Leaning |
Lehr
Replies: 3
Views: 7901
|
Forum: Technical Knowledge Base Posted: Thu Nov 01, 2007 3:20 pm Subject: M-38 Leaning |
Hello all: Am looking for help,ideas as to why my jeep(M-3 is leaning to the drivers side.. I measured from the ground up to the body even with the hubs and got the following measurements; Drive ... |
Topic: new to this forum and M-38s |
Lehr
Replies: 2
Views: 5065
|
Forum: Technical Knowledge Base Posted: Tue Oct 23, 2007 5:36 pm Subject: new to m-38s |
Hello: Thanks Wes for the info. I also received your request for the info on your survey. I will work on the answers probably tomorrow and send when finished. I am fairly comfortable with the comput ... |
Topic: new to this forum and M-38s |
Lehr
Replies: 2
Views: 5065
|
Forum: Technical Knowledge Base Posted: Tue Oct 23, 2007 10:00 am Subject: new to this forum and M-38s |
Hello all: I am new to this forum and to M38s, Im a long time owner of a willys mb and recently had an M-38 follow me home,its about 75% restored. Im nterested in finding all I can so I know what to ... |
|