Author |
Message |
Topic: M38 Rear Main Oil Seal |
Rod
Replies: 3
Views: 3735
|
Forum: Technical Knowledge Base Posted: Sat Jul 04, 2020 3:27 pm Subject: M38 Rear Main Oil Seal |
I asked this question over on the M38 boards on the G boards but I figured I would ask it here to get the most valuable response.
I recently installed an engine that I had built about 12 years ago ... |
Topic: M38 Wiring Harness Transister Flash Turn Signal Unit Mount |
Rod
Replies: 4
Views: 3131
|
Forum: Technical Knowledge Base Posted: Tue Apr 14, 2020 6:22 pm Subject: M38 Wiring Harness Transister Flash Turn Signal Unit Mount |
I am in the process of installing my wiring harness in the M38 and I will use the Solid state Turn signal controls from an M151. I will mount the controller on the inside of the firewall up and out of ... |
Topic: early M38 questions |
Rod
Replies: 19
Views: 19651
|
Forum: Technical Knowledge Base Posted: Thu Dec 16, 2010 3:22 pm Subject: early M38 questions |
Rick, I used the Gillispie paint 23070 which closely matches the factory paint on the M38s or at least what is under tags, plates, etc when you remove them. |
Topic: Ramsey 50 Restoration |
Rod
Replies: 48
Views: 53029
|
Forum: Technical Knowledge Base Posted: Fri Apr 16, 2010 7:19 pm Subject: Ramsey 50 Restoration |
....Bill, You might also send Rod an email to see where he got his nice shiney bearing support.
My hanger bearing is an original which came with my 50R winch. Before I mounted my winch setup on my ... |
Topic: New Radio Installation |
Rod
Replies: 5
Views: 8677
|
Forum: Announcements, News, Humor Posted: Mon May 09, 2005 8:00 pm Subject: New Radio Installation |
Chuck,
Looking good. I have the correct clamps for the power cord. But, I believe you have a couple of boxes of them.
Also I sent you a PM |
|