Search found 101 matches

Thanks. That's what I needed to know.

I'm restoring a 1952 M38. The brake drums are not in terrible shape but they would benefit from being turned. I don't know their past history. What should the thickness of the drum be? Or, what is t ...

Those great color photos are stills from he 1958 movie "The Hunters" and the driver is actor is Richard Egan.

I checked mine by putting the old one in and solving the problem. I should have said try swapping the condenser.

Check the condenser. I had the same problem with a condenser that was practically new. It went bad after only 140 miles.

I have a Harbor Freight pressure pot 40Lb. capacity. If I run it at max pressure for my compressor (about 110 psi) it does a fair job but it is very messy. I use a tarp and a shop vac with a screen ov ...

I just put my GPW engine in the frame using 2 nylon straps and a load leveler. 1 strap at the front of the engine between front mount plate and fuel pump, the other at the back near the rear plate at ...

D&L Bensinger has them listed. That's where I bought mine, NOS, severl years ago.

Congratulations on a great forum group. It has been a regular morning stop for me since I first found it. Tons of information.

I have a keyed ignition switch in the glove-box of my M38A1. I can turn off the ignition and take the key with me. The original ignition switch still functions normally when the key is in the on posit ...

Glad to hear its coming along and I will drop by the hangar. Come to Wind Creek if you can.

I use an original on my M38A1 and have had no problems. If you change to the solid-state type regulator you will have to have a voltmeter type gauge rather than the ammeter type that was original to ...

I used Midwest Military's floor supports and passenger-side floorboard. I didn't brace the tub as I should have and it appeared that the new floor panel wasn't going to fit but the floor panel was ver ...

I also recommend Midwest Military for all the parts you mentioned needing. I replaced all the hat channel floor supports, passenger floor and fuel tank well with their parts and the fit and quality wa ...

Try McMsater Carr. I'm not sure what size you need but they should have it.

http://www.mcmaster.com/#drive-screws/=qs4jgy


Create an account	Home · · Forums · · Articles · · Downloads · · Photo Gallery


PHP-Nuke Copyright © 2005 by Francisco Burzi. This is free software, and you may redistribute it under the GPL. PHP-Nuke comes with absolutely no warranty, for details, see the license.