Author |
Message |
Topic: carter ys-950 leak |
crvbs
Replies: 2
Views: 1619
|
Forum: Technical Knowledge Base Posted: Sun May 22, 2022 11:00 am Subject: carter ys-950 leak |
thanks going to pull it off right now. |
Topic: carter ys-950 leak |
crvbs
Replies: 2
Views: 1619
|
Forum: Technical Knowledge Base Posted: Sun May 22, 2022 5:24 am Subject: carter ys-950 leak |
Been trying to figure out why my m38a1 with a 950ys carter carburetor run rich. Pulled to air horn off while on the jeep and the bowl was empty. Put gas in the bowl and 10 minutes later it was empty a ... |
Topic: what was i thinking. |
crvbs
Replies: 5
Views: 2844
|
Forum: Technical Knowledge Base Posted: Mon Oct 11, 2021 3:01 pm Subject: what was i thinking. |
That the trouble. To do it right , it would cost a pile. Do at bubba style and you have 2500 to 6000 dollar jeep that you have the same in. Still think I ll trying get at least one running. |
Topic: what was i thinking. |
crvbs
Replies: 5
Views: 2844
|
Forum: Technical Knowledge Base Posted: Mon Oct 11, 2021 11:22 am Subject: what was i thinking. |
Frame on the one that turns over is not to bad. Neither are rust thru but one has heavy pitting. Just already have 1 and a cj2a may try and rebuild the one and clean up the other to a running chassis ... |
Topic: what was i thinking. |
crvbs
Replies: 5
Views: 2844
|
Forum: Technical Knowledge Base Posted: Mon Oct 11, 2021 8:54 am Subject: what was i thinking. |
https://imgur.com/a/0YWL7Yh Would you even think of trying to bring these back to life. Number 2 jeep turns over , Number 1 jeep is frozen . bodies gone. part them out or strip to frame and see if I ... |
Topic: m38a1 steering knuckles |
crvbs
Replies: 7
Views: 3428
|
Forum: Technical Knowledge Base Posted: Fri Sep 10, 2021 6:07 pm Subject: m38a1 steering knuckles |
When ahead and tore it down . Not really much to it so far. Waiting on bearings, tie rods and such. . Be here next week. Got some poppet and springs .for the transfer case. |
Topic: m38a1 steering knuckles |
crvbs
Replies: 7
Views: 3428
|
Forum: Technical Knowledge Base Posted: Thu Sep 09, 2021 5:20 am Subject: m38a1 steering knuckles |
ron think rv and boat storage on the handle. Quicker may have been a better word . I need to get it going fairly quickly as hunting season starts in october. What i've looked at it seems the knuckles ... |
Topic: m38a1 steering knuckles |
crvbs
Replies: 7
Views: 3428
|
Forum: Technical Knowledge Base Posted: Wed Sep 08, 2021 7:51 pm Subject: m38a1 steering knuckles |
My 53 m38a1 tie rods and steering knuckles have give out. Have a donor that has a axle and tie rod that seem tight. Would it be easier to swap axles and brakes or tear down existing axle and replace t ... |
|