Search found 25 matches

Hi all,

After a long period I just finished the M31A1 project. It was based on the M31C pedestal (quotes and details), but adapted to Wes M31A1 information.

Here goes some pictures:

http://w ...

Wes,

I agree with you. Also I just realize that the piston is offset from the spark plug hole.

I found some tips how to do it at Vernco website: http://www.vernco.com/Tips/id337.htm

Thanks

Wes,

Thanks for you very accurate explanation. I´ll try to do it without remove the head.

My idea is to fix the caliper on the plug hole (I don´t kno how), and using that caliper bottom pin, rot ...

Bretto,

Is it possible to create a new precise timing mark with this process?

I believe that´s my only option, since I´m doing it now by just "listening the engine". Considering this terrible k ...

I was trying to set the ignition timing on my M38, using the strobo timing light.
As per the manual, the pulley mark is a small dot, that should appoint to the BTDC or to the correct 5 degrees when i ...

Great!!

Thanks!

Hi Bubagun,

Yes, could you please post some pictures about the position and the fixation on floor?
Are you using the regular M31C?

thanks!

Hello, friends

After a long time I´m working on the M38 machine gun mount project. I´m basing my project on M31C Jeep Draw´s project (from Jon Rojers). So I´m trying to compare the M31C (good for ...

Here in Brazil, all kind of fuel have 25% ethanol (including high octane premium fuel). It's a problem, since old jeep fuel system are not ready for it.
Some rusty can grow on the top of fuel tank, b ...

LIt looks like a defective capacitor. You should have plenty of power at + coil terminal.

luciano

Fellows,

My M38's 24V generator regulator just died... I'm having problems to find another one in good conditions here in Brazil.
So if some colleague knows about where I can find a good one to b ...

Wes,

Once more, thanks for your support

Luciano

Hi fellows.

I'm looking for pictures and additiuonal informations about the installation of a M31C machine gun mount on a M38 jeep.
As far I know, this mount was developed for MB or GPW installat ...

I'm using same Pertronix Ignitor than Bill F.

Works fine, and if for some reason it fails, I have just to replace it for the pointer + condensor (on field).

Luciano

Helo fellows,

It’s very easy to find information about all MB’s and GPW’s tools. But I never found sufficient information about these items that originally came inside the M38 tool box.
Someone ha ...


Create an account	Home · · Forums · · Articles · · Downloads · · Photo Gallery


PHP-Nuke Copyright © 2005 by Francisco Burzi. This is free software, and you may redistribute it under the GPL. PHP-Nuke comes with absolutely no warranty, for details, see the license.