Search found 42 matches

Ryan found one the one he had and offered to check it for me. Hopefully that will be the solution. Thank you Ryan.

Greg

Still looking for a regulator. Ryan couldn't locate the one he has.

Thanks
Greg V.

I checked the voltage:

not running, 25.4 volts

running revved up, 33.5 volts!

So she's hot!

I also checked the ABC cable to the regulator and there doesn't seem to be any shorts. Continuit ...

Ryan: I'll send you a PM.

If I can pick up a mechanical regulator, will the installed voltmeter work, or will it need to be converted back to an ammeter?

I'll do some more checking on the output of the genny before I go too ...

My generator (25 amp) just decided to start overcharging. Scenerio: started in the evening, turned on lights, when the RPM's came up, belts squealing. Generator got warm. Pulled generator apart and in ...

Artificer:
Nice article on reading the vacuum gauge.

My reading is steady at 19.

The fuel tank has a Midwest Military replacement cap with the movable valve in it for opening and closing the v ...

To clarify:

I disconnected the supply hose coming from the fuel tank at the fuel pump. Routed it down past the tire into a pan, then turned the valve on near the firewall and watched the fuel flow ...

Put a new pin in the 2/3 fork and that helped a fair bit. It doesn't jump out as frequently and really only on a longer deceleration. There is a little wear in the fork faces but not enough to really ...

What about Seafoam vs Sta-bil for gas stabilization?
Greg

Now that my fuel issue could be solved, next!
When I bought my jeep, the brake and clutch peddles were froze on the shaft, when I test drove it, I had to pull the clutch up with my foot to engage it. ...

I have a M38, I'll take a stab at it:

Standing by the right rear corner (passenger side) looking forward.
There is a footman loop on top of the wheel tub (fender) real close to the right body sid ...

While diagnosing the problems with fuel on my M38, one my friends (Mr. Goodwrench for 20+ years) suggested I throw some Seafoam in the fuel to clean out the system. Claims he and others have used it w ...

My cap has a on/off vent in it also, if the vent to the air breather or check valve was stuck it should have been able to draw enough air through the cap I believe?

Vapor Lock: usually associated w ...

It's running fine now? Why?

Here's what I did today:
Closed the vent on the cap and put put 3 psi of air pressure thru the vent line that goes from the tank to the air filter. Used gas leak detect ...


Create an account	Home · · Forums · · Articles · · Downloads · · Photo Gallery


PHP-Nuke Copyright © 2005 by Francisco Burzi. This is free software, and you may redistribute it under the GPL. PHP-Nuke comes with absolutely no warranty, for details, see the license.