| Author |
Message |
 Topic: Distributor install |
xdragoon
Replies: 2
Views: 2307
|
 Forum: Technical Knowledge Base Posted: Sat Jul 31, 2021 12:36 pm Subject: Distributor install |
| Thank so much Wes |
| Topic: Distributor install |
xdragoon
Replies: 2
Views: 2307
|
Forum: Technical Knowledge Base Posted: Sat Jul 31, 2021 8:58 am Subject: Distributor install |
| I am getting ready to install my distributor and am wondering if there is a gasket that goes on the between the block and distributor? I am also missing the screw that attaches the distributor to the ... |
| Topic: IT'S ALIVE !!! |
xdragoon
Replies: 12
Views: 17292
|
Forum: Jeep Project Threads Posted: Wed Sep 25, 2013 4:58 am Subject: IT'S ALIVE !!! |
| Congratulations on a great job! If mine looks half as good, I will count myself lucky. |
| Topic: In search of the story of my M38 |
xdragoon
Replies: 12
Views: 11133
|
Forum: Technical Knowledge Base Posted: Tue Sep 17, 2013 5:52 am Subject: In search of the story of my M38 |
Check out page 15 of this article, it mentions Robert "Bob" Jaskowak and the Chosin few
http://www.kwva.org/graybeards/gb_06/gb_0610/gb_0610_final.pdf
Look here for info on the battle
http:// ... |
| Topic: PS Magazine |
xdragoon
Replies: 5
Views: 6199
|
Forum: Technical Knowledge Base Posted: Thu Apr 11, 2013 6:08 am Subject: PS Magazine |
| Thanks for posting this! |
| Topic: M38 Rear axle help |
xdragoon
Replies: 4
Views: 5986
|
Forum: Technical Knowledge Base Posted: Fri Apr 05, 2013 6:25 pm Subject: M38 Rear axle help |
Hi Wes,
Thanks for your reply. I have read that section many times and could not figure this out. It wasn't until I read Jimm's post that the light bulb went on. I now have the axle's installed. Tha ... |
| Topic: M38 Rear axle help |
xdragoon
Replies: 4
Views: 5986
|
Forum: Technical Knowledge Base Posted: Fri Apr 05, 2013 2:12 pm Subject: M38 Rear axle help |
| Thank you for the reply. I did search for rear axle but could not find that specific issue. You gave me the info I needed. |
| Topic: M38 Rear axle help |
xdragoon
Replies: 4
Views: 5986
|
Forum: Technical Knowledge Base Posted: Fri Apr 05, 2013 9:01 am Subject: M38 Rear axle help |
| I installed my axles last night and found that the left bearing race went in flush with the end of the axle tube but the right bearing race was protruding out by an 1/8 of an inch. It seemed to be ful ... |
| Topic: Brake light switch question? |
xdragoon
Replies: 4
Views: 6466
|
Forum: Technical Knowledge Base Posted: Fri Mar 22, 2013 8:52 am Subject: Brake light switch question? |
Hi Pat,
Andy sent me this info
LEFT HAND THREAD BOLTS AND SCREWS
Bolts and screws with left-hand thread shall be marked with symbols shown either on the
top of the head or on the point. Markin ... |
| Topic: Original Blue found in Battery Box |
xdragoon
Replies: 5
Views: 7148
|
Forum: Technical Knowledge Base Posted: Mon Feb 25, 2013 6:44 am Subject: Original Blue found in Battery Box |
Hi M38CDNBILL,
That is my jeep that Pat posted pictures of. I spoke with the Curator of the AirForce museum in Comox BC and sent him some pics. This is the paint code that he sent me.
"had the p ... |
| Topic: Steering wheel |
xdragoon
Replies: 17
Views: 14162
|
Forum: Technical Knowledge Base Posted: Fri Nov 23, 2012 5:41 am Subject: Steering wheel |
| The Canadian tire where I live in NS will loan tools. If you bring them back in the same condition you borrowed them in then there is no charge. See if the Canadian tire in your area has the same prog ... |
| Topic: M38Cdn with gas heater |
xdragoon
Replies: 12
Views: 10502
|
Forum: Technical Knowledge Base Posted: Tue Nov 13, 2012 8:19 am Subject: M38Cdn with gas heater |
| Does anyone know what the short pipes on each side of the front bumper were used for? I have these on my M38 CDN and up until now I thought they were added by a civie owner after the jeep left the mil ... |
| Topic: hello folks |
xdragoon
Replies: 11
Views: 13339
|
Forum: Announcements, News, Humor Posted: Thu Oct 04, 2012 5:18 am Subject: hello folks |
Hello, I'm in Lower Sackville.
I'm just about ready to remove the tub from my M38 CDN.
hkenty@ns.sympatico.ca |
| Topic: Hello from Canada |
xdragoon
Replies: 10
Views: 13049
|
Forum: Announcements, News, Humor Posted: Wed Sep 26, 2012 4:33 am Subject: Hello from Canada |
| Welcome from Nova Scotia |
| Topic: Strata Blue |
xdragoon
Replies: 9
Views: 16582
|
Forum: Technical Knowledge Base Posted: Mon May 09, 2011 5:51 am Subject: Strata Blue |
Here is the paint code for the RCAF as supplied to me from Rob Roy of the CFB Comox Air Force museum.
"I had the paint scanned at the Home depot. They said it might be too glossy to get a good mat ... |
| |
Forum FAQ
Search
Usergroups
Profile
Log in to check your private messages
Log in
