Sandpaper Grit...

[CJ3B]

Hello Gents!

Question... what sanpaper grit should I use for scuffing bare metal for application of self-etching primer?

Looking at working this weekend on the top-bow side brackets while my electical connectors arrive. I have them already in bare metal, but would like to scuff them appropriately in order to have the primer "bite" as required.

Also, should I sand after I prime? What grit here before painting?

Thanks a million!

Jorge
_________________
Regards to All,

Jorge
1952 M38
1965 CJ3B

[wesk]

Generally finish sanding before paint is 400 to 600 grit. Sanding primer depends on the primer used. These type questions are best answered by your paint supplier or the paint's manufacturer since the answers can vary widely depending on the materials used.
_________________
Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100

Mjeeps photo album: http://www.willysmjeeps.com/v2/modules.php?set_albumName=Wes-Knettle&op=modload&name=gallery&file=index&include=view_album.php

[CJ3B]

Done already, too.

I found a paint shop while driving to the office.

If the metal is bare, sand with 220 wet (lightliy), and apply 2 or 3 coats of self etching primer.

A light 400 grit wet sanding may be done if applying red oxide primer over the self etching in order to protect the parts better before painting...

Hope this helps anyone else!
_________________
Regards to All,

Jorge
1952 M38
1965 CJ3B