Joined: Jan 15, 2007 Posts: 16 Location: Norwalk,Ct
Posted: Sun May 29, 2016 1:55 pm Post subject: m38a1 d18 transfer case rear seal
Hi All; Would anyone have any experience on removing the rear seal of a d18 transfer case screw driver, puller,dynamite, any help would be appreciated thanks Gene
Joined: Mar 26, 2012 Posts: 189 Location: Lexington Park Maryland (Southern Maryland)
Posted: Sun May 29, 2016 3:19 pm Post subject:
A good hook type seal puller will work. You can also drive two sheet metal screws into it on opposite sides and then use them to pull on to remove the seal. _________________ TJ
53 M38A1 (project)
3/28/45 MB factory restoration project
Joined: May 14, 2009 Posts: 971 Location: South Dakota
Posted: Mon May 30, 2016 5:50 am Post subject:
You can remove the rear extension and push the seal out with a press, or find a small slide hammer "L" or hook that fits between the shaft and seal and reaches behind. Be careful you don't break the ledge the seals stops against. Work one side until it moves and then go opposite. Back and forth. G503 (Ron F.) has double lipped seals and also correct double wall seals. Good gasket sets too. I was very happy with them.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum