Posted: Fri Oct 14, 2016 9:59 am Post subject: death wobble woes and repair
I removed the single shim on the top pivot, and its much better, butstill not 20 lbs to move back and forth. Wiper seals are prettymuch shot out, at least on the passenger side. does anyone stock nos wiper seals? I bought replacements some time back, but they are not nearly what the original ones are. Is there any hope of finding nos?~ Swampy~ _________________ Scott
Joined: Feb 20, 2007 Posts: 606 Location: Illinois
Posted: Sat Oct 15, 2016 6:56 am Post subject:
If you have removed all the shims, you can also install a circular machine bushing between the bearing and cap to achieve the correct pre-load. A well-stocked hardware store will have a supply of various thicknesses. Look for them in the section of the store with all the specialty fasteners in little drawers. As far as the ball seals go, I didn't find them difficult to install at all. We are talking about the ones with the rubber strips backed by spring steel. Just compress the rubber strips back into the housings as you tighten the bolts. There are other types of ball seals, other early Jeeps used felt seals but those don't seal as well in my opinion. They don't add much countering drag to prevent wobble either. _________________ 1951 M38
Don't use the NOS seals, go with the later style. If you have no shims under the king pin caps, you need to replace all bearing cups and cones. _________________ Chuck W.
Dixie Division MVC #002
1952 M38/M100
M274A2
1964 CJ3B
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum