| View previous topic :: View next topic |
| Author |
Message |
Barrabas
Member
Joined: Feb 15, 2018
Posts: 12
Location: cebu philippines.
|
 Posted: Fri Feb 16, 2018 5:28 am Post subject: Transfer box output shaft . M38 |
 |
|
| M38. Anybody know the end float required on the output shaft of the transfer box on the m38 ? Im busy replacing the seal in there .....cant find any trace of shims ..... |
|
| Back to top |
|
 |
4x4M38
Member
Joined: May 30, 2014
Posts: 3447
Location: Texas Hill Country
|
|
| Back to top |
|
|
Barrabas
Member
Joined: Feb 15, 2018
Posts: 12
Location: cebu philippines.
|
| Posted: Fri Feb 16, 2018 7:31 pm Post subject: |
|
|
| Ok thanks 4x4. Ive managed to find a couple of you tube clips on the subject which are helpful . One problem i have, is that All the diagrams /schematics i have, show different arrangements regarding felt seals etc etc. There doesnt seem to be anything standardised . Be grateful if someone here can advise . |
|
| Back to top |
|
|
4x4M38
Member
Joined: May 30, 2014
Posts: 3447
Location: Texas Hill Country
|
|
| Back to top |
|
|
4x4M38
Member
Joined: May 30, 2014
Posts: 3447
Location: Texas Hill Country
|
|
| Back to top |
|
|
4x4M38
Member
Joined: May 30, 2014
Posts: 3447
Location: Texas Hill Country
|
|
| Back to top |
|
|
Barrabas
Member
Joined: Feb 15, 2018
Posts: 12
Location: cebu philippines.
|
| Posted: Sat Feb 17, 2018 2:23 am Post subject: |
|
|
| Hi yes thanks ....got that . Looks pretty comprehensive so ill go with the info as it appears in there . : |
|
| Back to top |
|
|
|
Forum FAQ
Search
Usergroups
Profile
Log in to check your private messages
Log in
