I use the M151 turnsignalswitch with controllight.
It is easy to install on the steering column.
I use a 'civil' flasherunit 24 volt and made a separate wiring ( wich is easy to remove )for the signals. I take 24 volt at the permanent 24 volt so the signals can work without ignition on. The signalswitch has 4 positions, one to flash on the 4 signals each side.
On the front i installed two signals from an VW GOLF, see on the pic.gallery ( good to see for the opposite drivers )and at the back i changed the blackout lens with a yellow one and put a 21 watt lamp behind it. first i used civil lights, but afterwards i replaced them with the originals. It looks better, and the turnsignals are good to see. During summer we also use our arm to indicate any change of direction.
btw your jeep looks nice and is almost done !
Erik _________________ 1942 GPW 71336 my son's jeep restored now
1951 M38 MC11891
1953 VW beetle (genuine german Käfer )
1957 fantastic wife
Thank you Wes & Erik. The controller I have has a green lite under the handle the part no. is M62069/1-2. The handle can move two slots up from center and one down from center. The part no. in the instructions for the controller is M62069/2-1. Maybe that is a typo error.
Ken _________________ Tropical Veteran
35th Inf. Reg. "CACTI" 4th I.D. VN
Amateur Radio K5XOM
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum