Joined: Mar 22, 2009 Posts: 27 Location: Vancouver, WA
Posted: Wed Mar 25, 2009 6:46 pm Post subject: Fan Motor 24V in the Hot-Water Personnel Heater Kit (M38A1)
Has anyone had any luck getting one of these apart to get to the bearings? Took it out because it was screaming like a banshee from $&%, no... more like a APU on F/A-18 spooling up...
Undone the 2 nuts and connector but it only come apart about 3/8".
Joined: Nov 02, 2007 Posts: 437 Location: Seguin, Texas
Posted: Wed Mar 25, 2009 8:24 pm Post subject:
Sounds like the brushes may be hanging up on the armature.....like maybe from a groove worn in the armature or a plate at the end of the segmented part. Is there a way to remove the brushes externally? If not you may need to find some way to hold them back. If its a permanant magnet motor the core of the armature may be magnetically sticking to the outside magnet. Good luck.
Try sliding the cases closed and chuck the shaft in a drill. have someone spin the armature with the drill while you are seperating the case halves. On some of those motors only one case half can be pulled off at a time. _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum