I am up at my folks for Thanksgiving and will be back home Sunday. I don't have my material handy, but I do know that each one of those bolts is listed with the dimensions needed for each in the ORD 9 SNL G-740. There is an index in the back to look up the page number of the part and the bolts are listed with the part.
I hope this helps and if needed, I can send you some stuff when I get back. _________________ Ryan Miller
MVPA # 22010
Joined: Apr 11, 2005 Posts: 42 Location: San Juan, PR
Posted: Sun Nov 27, 2005 4:44 pm Post subject:
Steering box to frame
If correct, 7/16"-20NF-3 X 3"
Fenders to body and grill, and then to the frame
- IF CORRECT, FENDER BRACE TO FRAME = 3/8"-24NF-3 X 1 1/2" (4 TOTAL)
- IF CORRECT, FENDER TO BODY = 5/16"-18NC X 6/8" (WITH INTEGRAL INTERNAL TEETH LOCK WASHER (8 TOTAL)
- IF CORRECT, FENDER TO GRILL (GUARD) = 5/16"-18NC X 7/8" (6 TOTAL)
Hood to the body
- IF CORRECT, HOOD HINGE TO BODY = 1/4"-20NC-2 X 5/8" ( 5 TOTAL)
Throttle linkage to the engine block
IF CORRECT, THROTTLE LINKAGE TO ENG BLOCK = 1/4"-20NC-3 X 9/16" (2 TOTAL)
Drivers side seet frame
IF CORRECT, DRIVER SEAT FRAME = 5/16"-18UNC-2A X 7/8" (1 TOTAL)
= 5/16"-18NC-2 X 5/8" (2 TOTAL)
Hope all are correct; used the ORD 9 SNL G-740 Army Supply Manual!
Best regards,
Jorge
PS: Sorry about the garage not being warm enough... I had my typical sunny 86F beach weather today down here in Puerto Rico! _________________ Regards to All,
There is a fourth bolt for the drivers seat, left hand side from under the rear fender well, into the rear of the seat frame... there should be a nut inside the frame tubing this screws into...
SCREW, int-teeth-lock washer, hex-hd, S, cd or znpltd,
5/16-24NF-2 x 1 7/8"
Please note this is a different thread than the other 3...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum