Posted: Sat Feb 18, 2006 11:48 pm Post subject: Dana 25 Front Axle "Vents"????
Are there "vents" on the back side of the Dana 25 axle (next to the sockets)? If so, mine are all messed up from a previous owners weld stick, and I'm not sure how I will fix them. They look like they use to be threaded with some type of nut on them. Hard to tell for sure beneath the globs of weld stick on mine. Can someone send a picture of what they should look like?
Adam,
I emailed you some photos. The front Mdl 25 axle is vented thru a capped fitting on the front cover near the top driver's side. It is masked by the tie rod. There are grease fitting installed in the holes used to fill the front hubs with grease, gear oil or knuckle pudding when needed. The outboard in the axle tube vent fitting are found on some rear axles. _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum