Joined: Aug 31, 2010 Posts: 96 Location: Rose New York
Posted: Mon May 07, 2012 5:33 am Post subject: Removing tranny on M38
Asked the same question here a couple of weeks ago and was advised to pull motor and tranny together, good advise but this weekend I pulled my tranny repaired it and put it back. You will need a good tranny jack and a very good friend... Get your jeep jacked up at least a foot, jack up the end of the motor behind the behind the bell housing, open the small plate on top of the bellhousing, remove the cable and the throwout bearing arm, jack up and stabilize the tranny and unbolt the driveshafts and unbolt the four bolts on the tranny. You also have to remove the cluch linkage and a few other things of course. Lots of luck..it not as bad as it seems.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum