Whats the trick to replacing driveshaft slip joint grease seal? No sure how to get the old seal over the splines? Also is there a source for new seals?
Brian _________________ Brian
1955 M170
1940 BSA M20
Shouldn't need any tricks. The seal is a cork split washer and the backup ring is a split steel washer as well. Just open and spread at the split and slip over skinny part of shaft. Slide the threaded cap on first! I didn't see any listed ant where. The dimensions are given in the ORD 9
Page 207 - 8333061 Seal, plain rubber split, 1" ID x 1 37/64" OD x 5/16" Thick. supersedes 7702465
Page 208 - 7772465, Washer, split cork 1" ID x 1 37/64" OD x 5/16" Thick. Superseded by 8333061
Walck's has the civvy felt sleeve which should also work:
For $2.05 _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
Forum FAQ
Search
Usergroups
Profile
Log in to check your private messages
Log in
