Posted: Wed Aug 20, 2014 9:32 am Post subject: AN/VRC 16/17/18 in M38
Were the above "old family" radio sets (Power Supply, Receiver-transmitter, Aux. Receiver) only mounted on an FT285 in place of the rear seat on the M-38? Was there anyway that they could be mounted on one of the rear fender wells? Have looked at the drawings posted on the forum and only found the one for the rear mount.
Larry _________________ Larry, 52 M38, 67 M416
Last edited by hanl3 on Wed Aug 20, 2014 7:35 pm; edited 1 time in total
Larry, I could have sworn I saw VRC-12 in your title last night! I see you edited it. I withdraw my VRC-12 treatise and point out that the GRC rear seat set-ups went there because there is just not room for more than then two large units on the wheel house in these jeeps. I would suggest splitting the set and put the R109 on the opposite wheel house. Or if you want a M38/M38A1 to look like it is carrying a normal radio set-up for them then set it up as a VRC-8, -9, or -10 or a VRQ-1, -2 or -3. Or you could remove your right seat and build an extended support on that side to handle the full length GRC set-up.
Post a photo of your radio set & mount.
(Larry, I noticed your email system is refusing the automated emails from our web site that are sent when one of your posts has a reply. You should check your mail settings and make sure the web site's messages aren't going straight to your trash box.) _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
Wes, after looking at your initial reply, I looked at my OP. I had keyed "16/17/16" when I meant "16/17/18". I have a AN/VRC-9 mounted on the right rear wheel house of the M-38 now. Was looking to change it out to the VRC-17 that I had mounted on the wheel house of my former M-38A1. I guess the few extra inches of the A1 allowed me to do that. Will have to decide now if I want to give up the back seat for a FT285 to mount the VRC-17.
Answered the separate e-mail you sent regarding the blocked e-mail problem.
Will post some pictures in my new photo gallery soon. Thanks for setting it up.
What would happen if you heated the two vertical tubes at their lower bend in the passenger seat and angled the seat back further forward? Measure the distance from the rear end of the wheel house to the top edge of the seat back then measure your radio set. If you only need the seat back to move forward a couple of inches then this would work. _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum