Posted: Sat May 30, 2015 4:50 pm Post subject: Felt dust shields for the input yoke and output flange
I am replacing worn yoke and flange on my transfer case, they have pitted rust and are worn down from the seals. There wasn't any any felt before the seal when I removed them (long gone I suppose) and wonder if there is any special treatment to the new felt dust washers before installation ? Oil ?
You can oil them with a light oil and squeeze the excess out then install them adjacent to the companion flange dust shield. If you don't oil them they burn from the rotational friction and harden up on the overheated edge. _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum