Early or Late

4x4M38 · Post by **4x4M38** » Tue Dec 07, 2021 3:57 pm

Don,
The Army mod uses a right rear light in place of the left, so you have two the same. Wes has plenty of original documentation and step by step instructions.

And a common driver mod is to just replace the original rear light covers with Gamna Goat covers. They are full width red lenses for more visibility.

Beauty is, you just use a screwdriver to change them.

Take care,

Naugha · Post by **Naugha** » Tue Dec 07, 2021 4:00 pm

Hi Ron.
At this point i’m just blowing smoke.... need to dig into the threads and albums more..... wouldn’t want to embarrass myself ..... again.

I would like to keep my rear cans unaltered.

4x4M38 · Post by **4x4M38** » Tue Dec 07, 2021 4:29 pm

Take a look at the Turn Signals file in Wes’ photo pages.

You can do that in your chair with a toddy.

Great reading.

4x4M38 · Post by **4x4M38** » Tue Dec 07, 2021 4:39 pm

Here’s a link from Wes’ pages.

http://www.willysmjeeps.com/v2/modules. ... _photo.php

You end up with two rear lights the same. You don’t have to change the doors, but you can very easily for better visibility. Simple to change back.

RonD2 · Post by **RonD2** » Tue Dec 07, 2021 6:44 pm

Choices and decisions about turn signals with or without black-out lights will pile up fast.
Remember to measure twice and cut once.

Naugha · Post by **Naugha** » Wed Dec 08, 2021 7:16 am

All good info.
Time to start a wiring harness thread.

Post by **wesk** » Wed Dec 08, 2021 12:43 pm

Don,

Why not just open a restoration project thread like all the others have done and keep this board in proper service as a short and sweet technical inquiry and reply system?

http://www.willysmjeeps.com/v2/modules. ... forum&f=14

Naugha · Post by **Naugha** » Wed Dec 08, 2021 2:24 pm

Done.
Moved info to Project Thread / OK Boomer.