Page 2 of 2
Posted: Wed Jul 19, 2017 7:12 pm
by w30bob
Hold the presses.........I found one. A buddy over on the M37 site heard my cries and pulled one off a parts truck he had. It's froze up, but I have it submerged in my Secret Sauce. Hopefully it'll free up. One of my other buddies on the M37 site is in contact with Anderson to see what it will take to get a small run of these valves made again. I'll let you guys know if he makes any progress.
regards,
bob
Posted: Tue Apr 03, 2018 1:19 pm
by RonD2
Hi Bob,
Any news from Anderson Brass?
Posted: Wed Apr 04, 2018 12:38 pm
by w30bob
Hi Ron,
I have to check. Since getting my jeep last year I've totally blown off the M37 guys.........but they should remember me. I'll see if any progress with Anderson has been made. I'll also keep an eye out for these valves at the east coast meets this Spring. I did pick one up last Fall at Red Ball for a buck, and have since restored it back to new. These are tough little buggers to find these days.
regards,
bob
Posted: Wed Jun 05, 2019 6:55 pm
by Chjames3
Reviving this thread instead of duplicating one. Trying to source a shutoff valve so I can finish my fuel line install. (Completely from scratch) Most of the old links are dead so any suggestions would be greatly appreciated!