What's a fair price on M38 Parts?
Posted: Wed Sep 23, 2020 8:42 pm
I have someone interested in some of my M38 mechanical parts and was hoping you guys could help me figure out the fair value of the following parts. All of the parts are used...
Bare L134 engine block...assume it's not cracked but will need to be bored and have the valve seats done.
Bare Crank...assume it will need to be ground.
Loose Pistons with connecting rods attached.
Head
T-90 floor shift with /D-18 transfer assembly with hand brake, crossmember and skid plate all still bolted together.
T-90 Side shift (missing top cover) with D-18 transfer (missing shift levers, no hand brake assembly at all, just a yoke) still bolted to together
Dana 25 front axle drum to drum.
Dane 44 rear axle drum to drum.
Drive shafts
Trying to be fair to me and the future buyer...thanks for your help!
Mike B
Bare L134 engine block...assume it's not cracked but will need to be bored and have the valve seats done.
Bare Crank...assume it will need to be ground.
Loose Pistons with connecting rods attached.
Head
T-90 floor shift with /D-18 transfer assembly with hand brake, crossmember and skid plate all still bolted together.
T-90 Side shift (missing top cover) with D-18 transfer (missing shift levers, no hand brake assembly at all, just a yoke) still bolted to together
Dana 25 front axle drum to drum.
Dane 44 rear axle drum to drum.
Drive shafts
Trying to be fair to me and the future buyer...thanks for your help!
Mike B