willysmjeeps.com

High every one "
I brought these items from a guy , can any one recognise whot vehicle
I was hopeing the loom might just be m38 or it can be used with out to
Much mod " it looks right , from the light switch then a cluster of connections
poss for dash then it splits to 2 which I presume is rear and engine bay,
Then thear is this snorkel (rear pipe) the pipe look good but the pipe clamps
Don't look right , they have a twist nearing the end , I have tried to load the
Pictures with this post but alass no can do so they are in my photo Gallery
if someone has time to look they are the last four of the album thanks,

The photos of the Wiring harness (Loom) looks correct for an M-38 with Douglas connectors. Each wire has a tag (number ) on it , compare that to the wiring schematic of the jeep.

The fording pipe you have is actually the front fording pipe and I would not use it as it is very deteriorated and worn. For an M-38 the clamps are wrong. no 90 degree twist in them, and they should all look the same,

You will need to learn how to post photos to get more input on this thread.

Hope this helps...

Yes I must learn "
The rear fording pipe is in side the rubber flex pipe
So regulator to Harness " charge" starter"(loom) is separate .

Have you been through Wes's album here?
http://www.willysmjeeps.com/v2/modules. ... _album.php

Nice pics of a NOS kit.

On Page 1 of my photo album files you will find "M38 Electrical" and on page 1 of "M38 Electrical" you'll find "Harness".





Don't overlook Page 2 of my Main photo album where you can "M Series Electrics"

On Page 2 of my Main Photo Album you will find "Fording Kits"









You can probably see now that my photo album has the potential to answer about 85% of technical questions often posted on our boards!

Thank you " it's good that someone is in control, I will study and spend time
Checking the numbers on the loom (harness )against data on the Goveners albums,I paid $70 for it which in UK money is £50 if it's not ,it's worth that
for the Douglas connections but it looks good so far .The exhaust pipe is in
Side the rubber hose ,I haven't pulled the pipe out yet

Your "fording pipe' is actual both of them. The flex (shot) was the intake "snorkel" one and the metal one inside is the exhaust or "snorter" pipe. The inner one may cleanup.

I have this drawing on my photo page. The measurements might help determine if your wiring loom is correct for the M38.
http://willysmjeeps.com/v2/modules/gall ... .sized.jpg