Fuel filter and vacuum pump. M38a1, 1971
Posted: Wed Jun 30, 2021 6:25 pm
Hi,
New here.
A couple early questions: 1) My vacuum pump copper line coming out of the pump has an ID of 2-3 mm, it is extraordinarily small compared to the rubber lines going to the wiper motors. Is this correct? What is the ID of this copper connection? 2) I have a copper vent line that came out of the housing, to the left of the primer handle connection- when facing the unit - BUT it wasn't connected at the other end, so where do I connect it? ( the end of the copper line is not flared or such and the jeep has fording).
Thanks.
New here.
A couple early questions: 1) My vacuum pump copper line coming out of the pump has an ID of 2-3 mm, it is extraordinarily small compared to the rubber lines going to the wiper motors. Is this correct? What is the ID of this copper connection? 2) I have a copper vent line that came out of the housing, to the left of the primer handle connection- when facing the unit - BUT it wasn't connected at the other end, so where do I connect it? ( the end of the copper line is not flared or such and the jeep has fording).
Thanks.