Page 1 of 1
Is the Heat control valve needed, if so how to adjust
Posted: Mon Apr 04, 2022 3:56 am
by arisLgr
M38 at home to do lots of work! So, can I disable the Heat Control Valve? If not where in the manual is it's adjustment?
Thanks,
Aris
Posted: Mon Apr 04, 2022 9:50 am
by Xamon
Wes's album under the L134, page 3. third picture.
Posted: Mon Apr 04, 2022 12:19 pm
by arisLgr
Xamon wrote:Wes's album under the L134, page 3. third picture.
Got it, does that mean that I cannot just disable it?
Posted: Mon Apr 04, 2022 1:01 pm
by arisLgr
Xamon wrote:Wes's album under the L134, page 3. third picture.
Sorry is this the correct link?
http://www.willysmjeeps.com/v2/modules. ... php&page=3
Posted: Mon Apr 04, 2022 4:57 pm
by jake138
http://www.willysmjeeps.com/v2/modules. ... _photo.php
Wes' photo
If you remove the plate from within the manifold, your exhaust gases will always circulate around the intake, heating the air and fuel entering the engine causing it to run poorly.
If you try to "disable" it's functionality by holding the plate in the hot position in Wes' photo, your engine will not reach operating temperature as quickly as it should *in colder weather.
If you're missing components I would recommend just repairing it. There is no adjustment once the components are assembled. If your assembly doesn't match the drawings, you probably have a broken spring, which can be easily replaced.
Read through some other posts on our forums:
http://www.willysmjeeps.com/v2/modules. ... de=results
Posted: Fri Apr 08, 2022 10:23 am
by arisLgr
Crystal clear, thanks Jake, it stays there and I'll make sure it works right!