willysmjeeps.com

Hi all

I need some help with back BO lights mountings/position.

I have a MD Juan repro tub, my problem is that I don’t have anything left of my original tub. So no reference to use.

What I would need some help with is, the position of the hole and what diameter it should be? Inches or in mm is fine.

And as a secondary thing is the actual mounting on the tub or rear bumper?

Jeep is a M606 1956

/Niclas
horney@m606.se

Niclas,
They mount in the tub. They pass into a hole on each side and fasten to a bracket.

Rgr that Wes

You don't have the pos of the holes ?
How far in from the sides and the bottom edge of the tub.
And the diameter.

( A digital picture with values on will be perfect )

I bet the pos. is the same on M38A1 and M606/A1/A2.
As I understand the tub are almost the same.

I need to know where to make the holes in my tub.

those brackets are they the same on M38A1 ?

BO lights seems to be same as on m38 m38a1 m151 ?!?

/Niclas

Got info that it's the same on a M38
So if a M38 owner could help me would be appreciated

/Niclas