M38A1 Steering Column Jacket
Posted: Sun Mar 19, 2006 12:55 pm
Hi All,
It may be a dumb question, but I'm trying to get my floorboards all squared away. Theres one area that puzzles me. I ordered from George @ AJP the half moon steering colmn jacket plates under the assumption that I needed them.
Looking at SNL G758, page 314, I see the floorboard setup diagram. However, I dont see the half moon plates. Were the half moon plates used on a certain production run? I have the upper floorboard of course, + the plate labeled "U" # WO-685679. It says that this plate superseces another, but I cant find what that plate looked like.
If I am only supposed to have 685679 -- how does the gasket get anchored down?
Btw, there are no holes in Plate U that will accept a half moon plate. However on the floorboard, there are holes that will accept the lower plate.
It may be a dumb question, but I'm trying to get my floorboards all squared away. Theres one area that puzzles me. I ordered from George @ AJP the half moon steering colmn jacket plates under the assumption that I needed them.
Looking at SNL G758, page 314, I see the floorboard setup diagram. However, I dont see the half moon plates. Were the half moon plates used on a certain production run? I have the upper floorboard of course, + the plate labeled "U" # WO-685679. It says that this plate superseces another, but I cant find what that plate looked like.
If I am only supposed to have 685679 -- how does the gasket get anchored down?
Btw, there are no holes in Plate U that will accept a half moon plate. However on the floorboard, there are holes that will accept the lower plate.