willysmjeeps.com

Hello Gentlemen......,
Beg to ask if someone would be so kind as to email me a couple pictures of M38A1 fuel/vacuum pump/fording valve/ tappet cup- check valve configuration.
Someone braised one of the right angle brass fittings on the tappet cover cup shut, and I intend to correctly reconnect as it should be. Everything is pretty much correct and all there, just some good ol boy rigging that needs to be fixed right. ~ Swampy ~

Just go to my photo album and review the necessary photos.

http://www.willysmjeeps.com/v2/modules. ... _album.php

Some specific sub albums are:
http://www.willysmjeeps.com/v2/modules. ... _album.php

http://www.willysmjeeps.com/v2/modules. ... _album.php


This is the basic side valve cover plumbing for the early M38A1 with factory installed fording plumbing.


Here's the rest of the system.


You will find answers to over 90% of your questions on any Willys M Jeep right there in my photo album.

The system is also covered in great detail in the M38A1 engine service manual TM 9-8015-1. Here again a source for at least 80% of all your Willys M Jeeps questions is the published and free on out downloads page service manuals for these jeeps.

http://www.willysmjeeps.com/v2/modules. ... oad&cid=60

Thank you again Wes. Figured it out after awhile just the same. Scary what folks can rig.......Wes, you are the greatest! Really don't know how folks would get along if it were'nt for you and your vast knowledge, and surely everyone will agree to that! ~ Swampy ~

You are too kind. I am just sharing what I am sure you will be sharing a few years from now!