Joined: Jan 10, 2006 Posts: 136 Location: Russellville, AR
Posted: Mon Jun 12, 2006 2:39 pm Post subject: Changing the front axle seals.
Can I change the seals around the knuckles on my front axle on a 52 m38 without takeing hub and all off? Havent gotten this far yet but im figuring that when I remove the cover off of the differential it will be milky.
Joined: Apr 15, 2005 Posts: 133 Location: Up State SC
Posted: Mon Jun 12, 2006 7:50 pm Post subject:
The kit I bought (and I have now found out there are better ones) had two piece metal out side retainers. If I remember correctly I had to cut the rubber and metal inner seal to just get it over the outside of the knuckle with everything apart. That was to stretch it just a small amount. I didn’t have to cut the felt seal. To do what you want you would have to cut both. The felt seal will be easy after it is cut. The metal and rubber one will be hard to stretch over the diameter of the axle housing. It can be done. I have seen it done on a Samurai before and it is very similar to a jeep in design. Just make sure all the joints are facing the top of the housing. RTV at the cuts would help out too.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum