Clutch and brake pedal assembly to frame

[Ryan_Miller]

Guys,

I am trying to figure out the assembly of the brake and clutch bracket and pedal levers.

Is there only one large washer and do I have it in the right place?

On the brake lever, do the two cotter pins hold it in place as the brake pedal rotates on the shaft?

I have been looking up photos in the manuals.

I am confused!




_________________
Ryan Miller
MVPA # 22010

[wesk]

The parts book should have shown 2 or 3 washers. In a way it does show two washers 1 1/32" ID x 1/8" thick. One in section 0202 for the (clutch) pedal shaft and one in 1206 for the Barke pedal shaft. The drawings and my photo make it look like 3 are needed but the master cylinder side plate could easily perform the same duty as the washer on that end.




_________________
Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100

Mjeeps photo album: http://www.willysmjeeps.com/v2/modules.php?set_albumName=Wes-Knettle&op=modload&name=gallery&file=index&include=view_album.php

[Ryan_Miller]

Thanks Wes,

That is what I was thinking, 3 washers.

I have two washers and must have lost one somewhere.


_________________
Ryan Miller
MVPA # 22010