Posted: Fri Feb 10, 2017 2:52 pm Post subject: M38 Parking brake, pivot stud casting boss, broken
M38 Transfer Case Parking brake pivot stud mount broken
Are there any good ideas about welding the parking brake pivot stud into the transfer case boss? A good chunk (corner) of the casting is broken off where the stud is supposed to pivot the 7687434 lever. I am guessing that this stud was pressed into place. There is enough material in the casting to locate the stud pretty firmly. Not sure if nickle rod would work. Is this pretty common? Any ideas? Thanks Joe in Minnesota
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum