Posted: Wed Mar 29, 2017 10:38 am Post subject: Brian 4x4m38 had a question on the side steps
I have a related question that Dave can
use the answer to.
The replacement steps all have a turned up vertical
edge. To install does one put this behind the cowl
or cut out the cowl and weld it flush? _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
Joined: May 30, 2014 Posts: 3447 Location: Texas Hill Country
Posted: Wed Mar 29, 2017 12:04 pm Post subject:
Thanks for moving Wes.
As built the steps are all one piece and part of the cowl.
My question was specific to installing replacement steps.
The ones on Ron's eBay listing are unusual as they do not have
a turned up edge. A second question is begged as to how you
install that step
But back to my original question. When installing the step with the
turned up edge do you slip the turned up edge behind the cowl and
weld everything up or do you spot the step and mark that upturned
edge on the cowl, cut out that portion of the cowl then weld the
upturned edge flush with the cowl sheet metal?
I've seen it done both ways. Just wondering which is the proper way.
Since they are aftermarket repair parts and their replacement is not specified, listed or explained in the manufacturer's manuals I believe that question
Quote:
Just wondering which is the proper way?
can only be properly answered by the manufacturer/distributor of the aftermarket panel. Any other comments would be nothing more than opinions unless the respondent had the manufacturer's instructions available to quote. _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum