Joined: Dec 25, 2016 Posts: 110 Location: Athens, Greece
Posted: Mon Apr 04, 2022 12:35 pm Post subject: Clarification on Valve adjustment please!
On the TM1804A I read on page 86 paragraph 80 that 0.016 clearance should be set on all valves, but further down under Servicability Standards on page 126 it gives for the Intake 'Valve to tappet clearance 0.116' and on page 127for the Exhaust valve it gives 'Valve cap to tappet clearance 0.016'
Please clarify this for me!
Aris _________________ Aris
Willys M38
1936 Cord Phaeton
1954 Mercury Monterey
1968 Corvette Stingray
1973 Mercedes 350SE
1974 Montesa Cota 247T
1982 Kubota B7100
Joined: Dec 25, 2016 Posts: 110 Location: Athens, Greece
Posted: Mon Apr 04, 2022 1:48 pm Post subject:
ok, got my English and inches right, it shoyld be 0.016 inch for all valves..... _________________ Aris
Willys M38
1936 Cord Phaeton
1954 Mercury Monterey
1968 Corvette Stingray
1973 Mercedes 350SE
1974 Montesa Cota 247T
1982 Kubota B7100
but further down under Servicability Standards on page 126 it gives for the Intake 'Valve to tappet clearance 0.116' and on page 127for the Exhaust valve it gives 'Valve cap to tappet clearance 0.016'
The 0.116 entry on page 126 is a Minimum clearance(NOT MAX) and is applied to only the intake stems. The entry 0.016 on page 127 is the MAX clearance between Exh valve rotator cap and tappet. Yes these entries can be confusing. _________________ Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum