View previous topic :: View next topic |
Author |
Message |
Cacti_Ken Member
Joined: Apr 20, 2005 Posts: 1021 Location: Silsbee, Texas
|
Posted: Sun May 08, 2005 6:35 pm Post subject: Right or wrong generator bolts/grommets |
|
|
I'm having some problems getting the bolts to work with the 24 volt generator on the M38. The generator bolt holes seem to be smaller than these bolts. I get a measurement of close to 7/16" on the drive end hole and the other end is worn in some. But these bolts are a little to big. Plus the grommet holes are a lot larger the bolt shoulders.
Do I have the wrong bolts and gromments? There is a typo on the .900 O.D. It should be .490" O.D.
_________________ Tropical Veteran
35th Inf. Reg. "CACTI" 4th I.D. VN
Amateur Radio K5XOM
Last edited by Cacti_Ken on Mon May 09, 2005 7:12 am; edited 1 time in total |
|
Back to top |
|
|
Ryan_Miller Site Administrator
Joined: Apr 03, 2005 Posts: 1634 Location: Kansas
|
Posted: Sun May 08, 2005 7:44 pm Post subject: |
|
|
Ken,
Those bolts kinda look like the civilian ones.
These are not great photos but the first one is a civilian and the second is military.
I found some NOS through Midwest Military or Mullins, I can't remember now. Grommets should be a one piece rubber. They are hard to get into the holes.
Will try to get you better photos.
_________________ Ryan Miller
MVPA # 22010 |
|
Back to top |
|
|
DJ Member
Joined: Apr 15, 2005 Posts: 289 Location: Wis.
|
Posted: Sun May 08, 2005 8:52 pm Post subject: |
|
|
BMJ can fix you up with new bolts and bushings. I got a set from them and they fit real good. Be sure to get the washers in the right places. |
|
Back to top |
|
|
wesk Site Administrator
Joined: Apr 04, 2005 Posts: 16250 Location: Wisconsin
|
|
Back to top |
|
|
OKCM38CDN Guest
|
Posted: Mon May 09, 2005 6:16 am Post subject: |
|
|
On my generator, After butchering the bushings to get them in the hole. I had to go with straight 7/16" x 2 1/2" bolts. The SNL called for bolts with 7/16" thread on them... |
|
Back to top |
|
|
Cacti_Ken Member
Joined: Apr 20, 2005 Posts: 1021 Location: Silsbee, Texas
|
Posted: Mon May 09, 2005 7:19 am Post subject: |
|
|
I made a typo error in the deminsions of one bolt in the photo. (error .900") (correct .490") I called the vendor that sent me the bolts and grommets and told him of my problem. He said they sent me the wrong ones. And the ones I got are probably for an MB. He said the M38 has 7/16" threads and shoulders.
They are suspose to be sending the right ones. _________________ Tropical Veteran
35th Inf. Reg. "CACTI" 4th I.D. VN
Amateur Radio K5XOM |
|
Back to top |
|
|
|