My tub photos from last weekend

Post by **Ryan_Miller** » Mon Mar 27, 2006 6:41 pm

Guys,

I worked on the tub last weekend and I think it is ready for paint. As you see it here on the Jeff Helps inspired rotessorie, I am going to start painting in the near future I hope!

Jeff_H · Post by **Jeff_H** » Mon Mar 27, 2006 10:30 pm

Ryan

Looks great! Like the shop as well. Any photo's of the inside?

Jeff

m38olddog · Post by **m38olddog** » Tue Mar 28, 2006 12:06 am

That tub looks mighty fine. And what a terrific rig to work on it! Nice job!

davem201m38 · Post by **davem201m38** » Tue Mar 28, 2006 1:19 am

That is one nice tub, looks good and solid both undwr the tank and in the floor of the tool box, yummy!,
All the best,
Dave

GregS · Post by **GregS** » Tue Mar 28, 2006 8:29 am

Very nice Ryan!

Nothing like laying down the top coat and seeing all that time of prep work was well spent!!

Greg

Galen · Post by **Galen** » Tue Mar 28, 2006 5:33 pm

Man, that's a nice tub! Awesome feeling to see it with a coat of paint after all the work getting it to that point, isn't it?

I second the motion, we need to see shots of the inside of your shop & all the goodies you have!

Post by **Ryan_Miller** » Tue Mar 28, 2006 7:47 pm

Thanks for the nice words guys!

I have replaced a lot of the sheet metal on the back half because the rear quarter panel corners were dented in badly and the rear floor was beat down.

I'll try to get some photos of the inside of the shop for you, but I have to clean it up a bit as it is a mess. This shop is a lot smaller down here in Texas than my dad's back home so I have to keep the equipment down to what I need for the part of the project I am working on.

I hope to start painting it in the next couple of weeks as time permits.

I want to get some measurements and some other photos for more articles while it is bare.

GIJOE290 · Post by **GIJOE290** » Tue Mar 28, 2006 8:30 pm

I concure, Nice tub! And a neat rotessorie (thingie)!

Good Job Ryan!