M-38A1 Driver's Side Fender Brace

OKCM38CDN · Post by **OKCM38CDN** » Sun Jun 02, 2019 6:43 am

I am restoring a 1954 M-38A1, I have both fenders although the passenger side is in need of lots of flat steel replacement I am attempting it. After replacing the floating weld nuts on both fenders I noticed that the driver's side does not have the hat channel bracing going all the way down so as to connect to the frame. It is cleanly cut just above the fender steel. So I am looking for just the channel at this point. If someone has a bad driver's fender and willing to part it out I would be grateful. Let me know what you have.

email me at kb1zq@swbell.net or via PM.

rgmutchler · Post by **rgmutchler** » Sun Jun 02, 2019 7:15 am

Hal,
I think classic enterprises makes the part you need.

Post by **wesk** » Sun Jun 02, 2019 9:35 am

It helps to let folks know which fender you have.

OKCM38CDN · Post by **OKCM38CDN** » Sun Jun 02, 2019 11:02 am

Thanks Wes, I have the late fenders and per your post there is NO extended bracing on the driver's side... That answers my question...

I wanted to be sure before I call the fender good prior to sand blasting it down the road...

I did check Classic Enterprises website and could find no bracing for the CJ5 / M38-A1 front fenders... maybe I missed it...