I am running all the control cables and starting on the wiring harnesses for my M-38A1. I have run into a problem; the fording control cable. The side that goes to the crossover pipe to at the carb is about 2 inches too short. An I am not sure of where the bracket for the cable that goes to the PVC valve goes or what it looks like.
I have been going thru the manuals and Wes' photo gallery and I am sure I have the cables going thru the firewall correctly, but cannot get them to a point to secure them.
Any assistance would be appreciated...
M-38A1 Fording Cable Routing...
-
OKCM38CDN
- Jeep Enthusiast
- Posts: 530
- Joined: Thu Feb 16, 2012 6:00 pm
- Location: Del City, OK
M-38A1 Fording Cable Routing...
Hal, KB1ZQ
TSGT, USAF (Ret)
1952 M-38 CDN CAR 52-31313
1952 M-100 Strick #104
1951 Willys Wagon (For Sale)
1954 Willys M38A1 201001205
Tornado Alley
Del City, OK
TSGT, USAF (Ret)
1952 M-38 CDN CAR 52-31313
1952 M-100 Strick #104
1951 Willys Wagon (For Sale)
1954 Willys M38A1 201001205
Tornado Alley
Del City, OK
-
wesk
- Site Administrator
- Posts: 16453
- Joined: Sun Apr 03, 2005 6:00 pm
- Location: Wisconsin
- Contact:
Cable "F: goes to the crossover tube clamp leg. Cable "J" goes to the vent control valve connected to the PCV valve.
Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
Mjeeps photo album: http://www.willysmjeeps.com/v2/modules. ... _album.php
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
Mjeeps photo album: http://www.willysmjeeps.com/v2/modules. ... _album.php