M-38A1 Driver's Seat Question...

OKCM38CDN · Post by **OKCM38CDN** » Wed Jan 13, 2021 4:00 pm

I am getting ready to mount the driver's side seat and looking over the SNL it calls for 3 bolts (two of one type and one of a different type).

My question is on the front left of the seat is a leg with a hole in it, it appears to sit against the fuel tank. Is there supposed to be a rubber plug or cushion there to prevent damage to the tank. If so I cannot seem to find it in the SNL.

TIA

OKCM38CDN · Post by **OKCM38CDN** » Wed Jan 13, 2021 4:36 pm

OOPs - When all else fails test fit the seat before asking question...

The point that I asked about is the place where it attaches to the body in the door. I inadvertently filled that hole when I was doing the body work. Now just need to drill it out and put the bolt and nut in place...

4x4M38 · Post by **4x4M38** » Wed Jan 13, 2021 8:52 pm

Hey, sounds like you filled the hole properly!