Top Bow, "rings, chains and pins"
Posted: Fri Aug 12, 2005 9:02 pm
I posted this on the GEE but thought I might catch an answer over here for those that don't get to the GEE.
I have just installed the windshield brackets that hold the rods from the top bows. I have also made the rods from the schematic on David Pizzaferrato's OD site.
Now the question. Does anyone have more detailed information than what the Ord 9 states as " 2 chains, 2 pins and 4 rings" for the method of holding the front of the rods in the windshield bracket?
I have left over chains and rings from MV Spares that I bought some time ago that I used on the passenger front seat pivot brackets. Are they correct for the application on the top bow rods? If so what would one use for pins? Cotter pins? Since I am asking, are the MV Spares correct for the seat pivot brackets?
Any detailed photos of NOS or original equipment would help.
Thanks for any help.
I have just installed the windshield brackets that hold the rods from the top bows. I have also made the rods from the schematic on David Pizzaferrato's OD site.
Now the question. Does anyone have more detailed information than what the Ord 9 states as " 2 chains, 2 pins and 4 rings" for the method of holding the front of the rods in the windshield bracket?
I have left over chains and rings from MV Spares that I bought some time ago that I used on the passenger front seat pivot brackets. Are they correct for the application on the top bow rods? If so what would one use for pins? Cotter pins? Since I am asking, are the MV Spares correct for the seat pivot brackets?
Any detailed photos of NOS or original equipment would help.
Thanks for any help.
